Spec Sheet

F770

System Specifications

Build Envelope (XYZ)

1,000 x 610 x 610 mm / 372,000 cm

3

(39.4 x 24 x 24 in. / 22,677 in

3

)

®

the widest build chamber (X direction) of any Stratasys FDM printer, the F770 provides the capability to build large parts or sizable

assortments of smaller parts.

The F770 features industrial-grade technology for consistent, reliable performance and accurate results. Available model materials

include two industry standard thermoplastics available in three layer thicknesses (slice heights). Soluble support material enables

complex designs and hands-free post-processing.

GrabCAD Print™ software powers a streamlined workflow by printing directly from CAD files. Insight™ software is also included

for more in-depth print file adjustment. The F770 is equipped with MTConnect, a manufacturing communications protocol, for

factory-floor connectivity.

  

n Red

nn White

n Light Gray n Black

n Yellow n Blue

n Ivory

ABS-M30™

  

XY part accuracy = +/- 0.254 mm (+/- 0.010 in.) or +/- 0.002 mm/mm (+/- 0.002 in./in.),

whichever is greater

Z part accuracy = +/- 0.200 mm (+/- 0.008 in.) or +/- 0.002 mm/mm (+/- 0.002 in./in.),

plus 1 layer height

Software GrabCAD Print, Insight, Control Center™, MTConnect enabled

Workstation Compatibility

Wired and wireless (with USB dongle) network interfaces using

standard TCP/IP protocols at 100 MBPS minimum

Wireless Network Connectivity

99 cm (39 in.) clearance on each side of printer

Audible Noise/Acoustics

54 dBA

Power Requirements

3 phase, 208V, 30A, 5 wire, 47-63Hz frequency

Regulatory Compliance

CE, cTUVus, RCM, EAC, FCC Part B

Facility Requirements

Double-door width for installation, vacuum pump within system – no shop air required, forklift

uncrating and installation

Spec Sheet

© 2023 Stratasys. All rights reserved. Stratasys, the Stratasys Signet logo, FDM, and Fortus are registered trademarks of Stratasys Inc.

F770, ABS-M30, SR-30, GrabCAD Print, ProtectAM, Insight and Control Center are trademarks of Stratasys, Inc. Red Hat is a registered

trademark of Red Hat, Inc. in the United States and other countries. All other trademarks are the property of their respective owners,

and Stratasys assumes no responsibility with regard to the selection, performance, or use of these non-Stratasys products. Product

specifications subject to change without notice. PSS_FDM_F770_A4_0223a

alphacam GmbH